williamsjettenders.com
williamsjettenders.com
New Engine Break-in Period
Consult your BRP engine operator’s manual.
A break-in period of 10 hours is required before continuous operation at full throttle. To achieve
a good break-in, a maximum of
3
/
4
throttle should be observed, however, brief acceleration and
speed variations contribute to a good break-in. Williams suggest that after the first 10 hours of
operation, the engine be checked by an authorized BRP/JPS ROTAX marine engine dealer.
The break-in period is very important and must not be neglected.
Fuelling
As part of its pre-delivery inspection your new Sportjet has been fully tested and
drained of fuel.
•
Ensure ignition is in OFF position.
•
Remove seat cushion to expose filler cap.
•
Re-fuel in a ventilated area.
•
Do not overfill the tank; be careful not to spill fuel.
•
Tighten fuel cap securely after re-fuelling.
•
Open engine hatch and inspect bilges after re-fuelling.
•
The filler cap has an integral breather.
Do NOT hose around the fuel filler area as water may enter the fuel tank.
Minimum Octane Rating
CAUTION.
Do not use fuel from fuel pumps labeled E85.
Use of fuel labeled E15 is
prohibited by US EPA Regulations.
North America
Rest of the World
RON+MON/2:
87
91
RON:
92
95
150 (ECT)
•
-
150 (ECT)
•
-
250 (ECT)
•
•*
250 (ECT)
•
•*
*
For optimum engine performance
Fuel containing Ethanol can result in problems in the fuel system and engine, resulting in:
•
Starting and operating difficulties.
•
Deterioration of rubber or plastic parts.
•
Corrosion of metal parts.
•
Damage to internal engine parts
Before Use
Tube pressure will fluctuate with temperature. Inflate tubes in sequence to 250 mB/3.6 psi.
Failure to observe this will compromise the sea-keeping ability and watertight integrity of the
boat. Inflation valves are fitted with quarter-turn locks to enable rapid deflation.
CAUTION.
Tubes must be inflated in the correct sequence to prevent
over-inflation.
•
Set valves to shut and inflate tubes evenly, starting at rear/right, rear/left, then forward valves.
•
Check bilge for fuel or water contamination.
•
Tighten footwell drain plugs.
•
Ensure towing valve is set in open position.
•
Check engine cover latches are secure.
Safety Check!
WARNING.
ALWAYS attach yourself to the safety lanyard when engine is running.
Before setting off as a precautionary measure always test lanyard for its functionality by
pulling away from its seating – engine should always stop.
WARNING.
NEVER operate the boat when bathers are using the boarding ladder
,
as risk of serious injury exists from reverse deflector.
WARNING.
NEVER investigate engine bay with engine running or ignition on.
Starting Your Sportjet
Ensure boat is in a depth of at least 0.95 m/3 ft
of water.
1
Turn ignition key to ignition position.
2
Run bilge blower for 4 minutes.
3
Secure any loose ropes that could get sucked into
jet unit.
4
Ensure shift lever is in neutral position.
5
Connect safety lanyard to switch.
WARNING.
Personal injury may result if
not attached.
6
Press Start/Stop button to start engine.
7
Test safety lanyard for correct functionality
(see
Safety Check!
).
Warning Lights
CAUTION.
Risk of engine damage.
In the event that a warning lamp or buzzer
activates during use, STOP engine immediately, investigate cause and/or contact your
authorized Williams Dealer.
2
1
1
Battery isolator/Ignition key
2
Engine start/stop button
English
8
9
English
