A WILKINSONSTAR PRODUCT 02-18 ISSUE 1
Parameter AutoSaving
The parameters having been adjusted will be AutoSaved in the parameter group currently used (no
AutoSaving will be done in the case that no operation is done after parameters are adjusted and the
machine was turned off in 5s’ time). When the machine is turned on next time, the parameters in this
parameter group are just the parameters used last time. When the welding mode and operation mode
are reselected, AutoSaving will be done in 10s. No special save key and manual saving operation is
available for this machine.
Protection function
When the overcurrent indicator illuminates and the digital meter displays
“E-1”, it indicates that overcurrent occurs. Restart the machine, and
welding can be continued.
When the under-voltage indicator illuminates and the digital meter displays
“E-2”, it indicates that the mains voltage is overly low, and welding can be
recovered when the mains voltage goes into normal.
When the overheating indicator illuminates and the digital meter displays
“E-3”, it indicates that welding is forced to stop because the main circuit of
the machine gets overheated. In this condition, It is unnecessary to turn off
the machine, but just wait a few minutes, and then welding can be
continued.
When the current sensor fails and the digital meter displays “E-4”, welding
may still be carried out. However, the current value at this time is
inaccurate.