11
EN
Use
Backside LED
(Fig. 1/
7
):
0–24%
1 blue LED strobe flash
25–49%
2 blue LEDs strobe flashes
50–74%
3 blue LEDs strobe flashes
75–99%
4 blue LEDs strobe flashes
100%
4 blue LEDs remain lit
NOTE
: During the charging process, the heating of the tool housing is normal. The tool
does not work during charging. If there is no response when the ON/OFF switch is pressed
during charging, it is not a tool fault.
NOTE
: The tool works best at normal room temperature.
6.2 Preparation and operation
1. Place the glue stick (Fig. 1/
4
) in the opening provided on the back of the tool. Check that
a glue stick is fitted properly and only use glue sticks with a diameter of 7 mm.
2. Press the ON/OFF switch (Fig. 1/
2
) for approx. 2 seconds.
3. Red LEDs on the back of the tool will light up to indicate that the tool is heating up.
4. After approx. 15 seconds' heating, the tool is now ready for operation. When the tempera-
ture is high enough, LEDs will change from red to blue. The tool is ready for operation.
EN
08/01/21
Original instruction manual
