Wieland podis, System Manual

Page: 98 / 100

Wieland podis

system
Manual V 1.03 / ref. no. 00.000.0059.0 / 28.03.2001
6.9.4 Switching on MFI
Sequence for switching on (operating sequence):
(1) Enable
(2)
Release brake (brake must be released before the
direction information is given)
(3) Ramps, speed
(4) Right/left
Brake Left Right Enable Speed Ramp What is happening Display Status byte
0 0 0 0 0 0 Motor OFF OFF 1100 0000
0 0 0 1 0 0 Motor OFF – output module is enabled OFF 1100 0000
1 0 0 0 0 0 Motor OFF – brake is ventilated OFF
1 0 0 1 0 0 Motor OFF – output module is free,
brake is ventilated OFF 1100 0000
1 1 1 0 0 Motor OFF – speed data is missing d 1110 0000
1 0 1 1 200 0 Motor ON – clockwise rotation with a
ramp time of 0 (characteristic curve) d 1110 0000
1 0 1 1 200 5 Motor ON – clockwise rotation with a
ramp time of 5 (characteristic curve) d 1110 0000
1 1 0 1 200 5 Motor ON – anti-clockwise rotation with
a ramp time of 5 (characteristic curve) b 1110 0000
1 1 1 1 200 5 Invalid state, motor stalls OFF 1100 0000
Error Display LEDs Status byte Diagnostics Measures
Errvolt 1 ERR 11X0 0001
0000 0000
Error in power supply 400 V
-
mains voltage is missing
- phase failure or unbalance
Caution after restart:
If the 400 V supply is still not
present, the error code ”1” is also
displayed.
After switching on the 400 V
supply voltage however, the error
is automatically acknowledged
Check mains voltage
Possible internal fuse defect
Reset error with control byte (value
80hex)
Warnccrrnt
(transient overcurrent) - OL 11X0 0010
0000 0000
Warning: the motor is experiencing
overcurrent
- incorrect nominal current set
- high-inertia starting of motor
- transient overload of the motor
Correct nominal current setting
Reset error with control byte (value
80hex)
Errcrrnt
(overcurrent
disconnection) 7 ERR 11X0 0100
0000 0000
Motor disconnected due to
overcurrent
- incorrect nominal current set
- motor is blocked
Correct nominal current setting
Reset error with control byte (value
80hex)
Comerr
(Communication error) - - 11X1 0000
0000 0000
Display: if faulty communication to
the motor starter occurs (due to
faulty telegrams or incorrect
operator inputs e.g. excessive
speed if a low maximum speed
has been set) Error display is automatically reset
once the fault has been rectified
Digital output has short
circuit 2 ERR - Digital output has a short circuit Remove short circuit
Error display is automatically reset
once the fault has been rectified
Braking relay error 5 ERR 11X0 0000
1000 0000
Error with braking relay Check motor connection/cable