widos HRG 6 Segment, Working Instructions Translation

Page: 26 / 36

WIDOS
Einsteinstraße 5 Phone +49 7152 9939 0
Wilhelm Dommer Söhne D-71254 Ditzingen Fax +49 7152 9939 40
GmbH info@widos.de Internet: www.widos.de
06/06/19 Working Instructions WIDOS HRG 6, Segment Page 28 of 47
7 Maintenance / repair / transport
7.1 In general

Replace damaged pieces immediately, be particularly carefull with electric parts.
- Dirt and humidity are very good current conductors.
Prescribed maintenance and inspection works should be performed in time. The DVS
gives the advice of inspection works after 1 year.
For machines with a specially high usage percentage the testing cycle should be
shortened.
The works should be performed at the WIDOS GmbH company or by an authorized
partner.
7.2 Basic machine

The piston rods of the basic machine are to be kept clean and need to be covered with a thin oil
film if they are not being used.

The linear guides must be cleaned every week, e.g. with a brush. Dirty guides may cramp and run
heavily.

Check the linear guide carriages every 3 months and grease them over the lubricating nipple if
necessary.
7.3 Clamping elements

For a long service life clean and grease regularly the threaded spindles and the joint parts which
are used for clamping the pipes.
7.4 Checking and refilling the hydraulic oil
Check the oil level in the hydraulic system regularly.

Remove the cover of hydraulic aggregat on the rearside.

Screw off the red cover srew on the top of the tank.

Pull out the integrated oil dipstick, clean it with a dry tissue and insert
it again in the tank.

Then turn out again and check the oil level. It must be between the
marks.

If the oil level is under the marks, add oil of the quality HLDP 32.
Screw plug with oil dipstick