Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
20.08.2014 Working
instructions
WIDOS 4000 WM
Page 24 of 68
4.5. Elements at the planer
In order to activate the planer motor press and
hold the switch by pressing the holdover key
additionally at the same time.
Once the planer motor is activated, press: < > in
order to switch the planer on.
For planing the pipe ends, the planer must always be locked in the front of the machine.
For lifting and lowering the locking bolt, push the lever to the right side.
For locking, pull the lever to the front.
If the planer is in initial position in the rear, the locking bolt must be lifted and the lever must be
locked in position (front).
If the planer is in planing position, the locking bolt must be lowered in the opening of the basic
machine and the lever must be locked in position (front).
Switch
Holdover key for holding the pressed switch
Lever to the side,
position: unlocked
Lever to the front,
position: locked
