Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone ++49 (0)7152 / 9939 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
++49 (0)7152 / 9939 - 40
website: www.widos.de
email: [email protected]
01.02.2012
Working Instructions WIDOS 2500 / OD 250
Page 16 of 45
5. Starting and operating
The instructions of this chapter are supposed to initiate in the operation of the machine and lead
during the appropriate starting of the machine. This includes:
•
the safe operation of the machine
•
using all the possible options of the machine
•
economic operation of the machine.
5.1. Starting
The machine may only be operated by initiated and authorized persons.
For the qualification, a plastic welding exam can be taken according to DVS and
DVGW.
•
In situations of danger for persons and the machine, the mains plug has to be unplugged
immediately.
•
After completion of the welding work and during breaks the machine has to be switched off.
•
Further take care that no unauthorized person has access.
•
Protect the machine from wetness and humidity !
•
According to VDE 0100, the use on construction sites is only allowed with a power distributor
with a FI-security protective switch.
•
Connect the heating element and planer to the mains supply (230 V / 50 Hz) / (110 V /
60Hz).
Lay electro wires carefully (danger of stumbling!)
•
Take into account the surrounding conditions:
-
The welding may not be performed under direct sun rays influence.
•
If the surrounding temperature is under 5°C / 41°F, measures have to be taken:
-
Preheat the pipe ends if necessary.
•
In addition, take measures against rain, wind and dust.
5.1.1. Assembly of the machine
•
Detach the clamping handles of the transport case and lift off the case in an upward
direction.
•
Turn the case upside down with the open space on top and put it on the floor.
•
Put the case floor together with the machine onto the open case.
•
Refit the screwed-off heating element handle.
•
Connect the planer to the local power supply (230 V / 16 A / 50 Hz) / (110 V / 16 A /
50-60 Hz).
•
Connect the heating element to the local power supply (230 V / 16 A / 50 Hz) / (110 V / 16 A
/ 50-60 Hz).
The machine can be operated now.
