23
FAULT DIAGNOSIS
Fault Diagnosis - User Maintenance
The appliance is fully performance tested after assembly. Providing it
has been correctly installed and is operated as advised, difficulties
should not arise. In the unlikely event that you experience problems
with your appliance then the following procedure will enable you to
undertake basic fault finding before contacting the person responsible
for installing your shower.
Shower temperature
too cold.
Hot water cylinder
temperature less than
12°C above shower
temperature.
Adjust cylinder temperature.
Note!
It is recommended stored
water temperatures do not
exceed
65°C
.
Maximum showering
temperature too hot.
Maximum temperature
incorrectly set.
Reset maximum temperature.
Refer to
COMMISSIONING
.
Malfunction
Cause
Remedy
Maximum temperature
incorrectly set.
Reset maximum temperature.
Refer to
COMMISSIONING
.
Spray plate blocked.
Clean spray plate. Refer to the
instruction manual supplied with
the
shower fittings
.
Inlet filters blocked.
Contact your installer.
Isolating valve partially
closed.
Open valve.
Contact your installer.
Plumbing system fault.
Blend temperature
unstable.
Pump does not
operate.
Electrical supply failure.
Contact your installer.
PCB failure.
Contact your installer.
Potentiometer failure.
Contact your installer.
Motor overheated,
thermal switch operated.
If the thermal switch operates
repeatedly contact customer
service for further advice.
Continued
