14
Push-fit
Release
Tool
Blanking
Plug
Inlet
Manifold
4.
Loosen the three cover securing
screws and remove the shower
unit cover.
Note!
The cover securing screws
are captive and should
not
be
unscrewed fully from the unit case.
5.
Insert the push-fit release tool
between the flange of the blanking
plug and the inlet manifold collet,
and lever the plugs outward. Whilst
holding back on the collet, pull out
the appropriate blanking plug by
hand.
6.
Position the shower unit on the
wall and mark through the three
fixing points.
Note!
Installers may wish to obtain
alternative proprietary cavity fixings
for dry lined, stud partition or dry
partition wall structures.
7.
Use the push-fit release tool to
push the grey collars into the
manifold to release the shower unit
from the supply pipes.
Warning!
Ensure there are no
buried cables or pipes near the
fixing points before drilling.
8.
Drill 9.5 mm holes in the wall and
fit the rubber wall plugs supplied.
Collet
Fixing
Points
Screws securing
the cover.
Screw
securing
the cover.
