![background image](http://html1.mh-extra.com/html/whynter/cdw-6831wes/cdw-6831wes_instruction-manual_978379011.webp)
11
Installation Instructions
Important
1. Once you open the water supply line, (even if it is closed immediately thereafter), the inlet hose will be pres-
surized.
2. To relieve water pressure from inside the inlet hose, (make sure the water line (faucet) is closed): press and
hold the red pressure relief button on the quick connect until the flow of water stops.
DANGER
DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE SUPERVISION OF CHILDREN IS
ALWAYS IMPORTANT AROUND APPLIANCES.
NOTE:
Hard water conditions will adversely affect the washing performance of your dishwasher. Hard water conditions
will also contribute to 'lime' (white film substance) deposits and/or 'scaling' on the stainless steel surface of the
dishwasher tub and heater element, located in the sump underneath the removable filter screen. To assist in
minimizing these conditions, it is recommended to periodically operate/
rinse the inside of the dishwasher
while empty
using 1 cup of white vinegar at least once a week.
FAUCET WASHER
If your existing faucet is not compatible with the quick con-
nect faucet adapter connection:
Both rubber washers must be installed inside the faucet
adapter if your faucet is inclusive of a female type
(threaded) connection. (Fig. 10a)
Use only the standard rubber washer (0.2”/5mm thick)
supplied within the adapter if your faucet is inclusive of a
male type (threaded) connection. (Fig. 10b)
Fig. 10a
Fig. 10b
Connect the quick connect assembly to the faucet
•
Run
the
garbage dispos
al
, if you have one, to clean
out
the disposer and thus allow water to drain from
the
sink through the disposer and down the drain.
•
Run
the
hot water faucet to purge cold water from the
hot
water line. The hot water must be between 120°F
and
150°F for best wash performance.
•
Move the dishwasher to a position just in front of the
sink.
•
Pull the quick connect adapter and its hoses com-
pletely out from storage compartment at rear of the
dishwasher.
Attach the quick connect adapter to the faucet adapter
following the three steps below:
Depress the locking collar at the top of the quick
connect adapter.
Place the quick connect adapter completely over
the faucet adapter.
Release the locking collar. The quick connect
adapter should now be locked onto the faucet
adapter. (Fig. 11a)