21
Starting a Program
At the End of the Wash Cycle
When the washing cycle has finished, the buzzer
alarm
will sound for 8 seconds. Turn off the dishwasher using
the ON/OFF button, shut off the water supply and open the door of the dishwasher. Wait a few minutes before
unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible
to breakage. They will also dry better.
The dishwasher will power off automatically after 30 minutes without any operation.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap.
3. Open the door carefully. Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool
down around 15 minutes before removing from the dishwasher. Open the dishwasher's door, leave it ajar
and wait a few minutes before removing the dishes. This will allow the dishes to cool and assist in the dying
process.
4. Unload the dishwasher. It is normal for the dishwasher to be wet inside.
Forget to Add a Dish
A dish or item can be added any time before the detergent dispenser opens.
1.
Press the Start/Pause button
2.
Open the door a little to stop the washing
3. Wait 30 seconds for
the spray arms
to
stop working,
then
open the
door completely
4.
Add items
5.
Close the door
6.
Press the Start/Pause button, the dishwasher will r
esume within
10
seconds
Rinse Aid Warning Light
When the dishwasher detects that the rinse aid dispenser needs to be refilled, the rinse aid warning indicator
will illuminate. See section “B. Fill the Rinse Aid Dispenser” on pages 13-14.
Note: If water spots are not visible and satisfied with the drying results, using a rinse aid is optional.
Program Completed Light
At the end of each wash program, the
Program Completed indicator will illuminate indicating that program
has completed.
Water Faucet Indicator
When the dishwasher detects that water pressure is low, the water faucet indicator will illuminate and the
dishwasher will stop temporarily. Make sure that the incoming water pressure should be between 15 and 20
pounds per square inch (psi).
1. Turn off dishwasher.
2. Remove inlet hose from the dishwasher.
3. Check water pressure.
4. Once water pressure is corrected, install the inlet hose onto the dishwasher.
