37
11.4
Display information
Splash Screen
– upon powering on the controller, the display initially shows a message that pertains to
the controller configuration. The two possible configurations are “RGD” and “TOR”. The RGD
configuration resets the current wheel count back to zero after a train has passed for approximately 45
seconds. The TOR configuration does not reset the wheel count back to zero and simulates one continuous
train.
Screen Time-Out
– If there is no input from any button on the controller within approximately 90
seconds the display will turn off. Press any button on the controller once to turn the display back on.
(Note: the button pressed to turn the display back on will not function other than to just turn on the
display)
Default Screen Direction A
– this is the default screen that appears upon powering on the controller. The
default setting for the controller upon initial installation will be 3 wheels and 5 steps. The wheel and pump
settings on Line 2 can vary depending on what they were upon powering down the box previously.
Line 1 – Total Wheel
and Pump Steps for
direction A
Line 2 – Wheel count setting, direction, and pump step setting
Line 3 – Current wheel count and voltage of battery
Line 4 – Will display various status and error messages. (See troubleshooting section for clearing errors)
Direction B Screen
– press the Direction Button once from default screen to access the direction B
information screen.
Line 1 – Total Wheel and Pump Steps for direction B (NOTE: there will be no counts on this screen with
single direction cable)
Line 2 – Wheel count setting, direction, and pump step setting
Line 3 – Current wheel count and voltage of battery
Line 4 – Will display various status and error messages (See troubleshooting section for clearing errors)
Note: Message “Single Sensor Cable” will appear on Direction B Screen if using a single sensor system
that does not allow dual direction capability.
Totals Screen
– press the direction button
(6)
until the Totals Screen appears to access the totals for wheel
counts and pump steps
Line 1 – Total
Wheel Counts for A & B
and Pump
Steps for direction A or B
combined