White Magic PRO 1900, Owner'S Manual

Page: 9 / 90

INSTALLING MACHINE INTO TRUCK
1. Remove the side covers from the machine. Place the two black iron
pipes through the ring lift points on the lower frame rail. Be sure to
clamp the pipes to the forklift as the machine is top heavy. Use these
pipes to lift the machine with a forklift and place in the truck.
2. The machine unit should be placed in the truck and jockeyed into
position prior to drilling of mounting holes for either section.
3. Situate the machine as close to the driver’s side wall as possible
without touching. Align the right hand side of the machine so it lies
even with the sliding door post and the driver’s side post. See
diagram under “Placement of major components.”
4. Prior to drilling the holes that bolt the machine to the floor, assure that
there are no components under the vehicle which will be damaged,
such as fuel lines, electrical wires or hydraulic lines.
5. Always use the supplied reinforcement brackets (J433) under the floor of van when
bolting the machine in place.
6. Once the machine is securely bolted in place, slide the 3" x 90
degree muffler sweep onto the blower pointing down. Mark the floor
approximately where the center of the sweep would go through the
floor, them remove sweep and drill with a 3-1/2" hole saw. Do the
same for the 1-1/2" sweep from the exhaust muffler and drill a 1-
¾" hole saw through the floor.
7. Clamp the 3" x 90 degree muffler sweep in place on the blower
output directed toward the new hole in the floor. From under the van
mount the other O3" x 90 degree muffler sweep to the first sweep.
Attach the muffler and hanger as shown in the diagram.
8. Clamp the 1-1/2" expanded muffler pipe to the 1-1/2" muffler
sweep and place through floor, then clamp in place to the muffler
output.
9. With a 1-1/8" hole saw drill a hole directly under the pop off
valve through the floor.
10. Run the pop off valve hose through the floor.
11. Seal all holes through the floor with high temp silicone caulking.
6