INSTALLING THE WALL MOUNT KIT
1.
If removed, reinstall the top panel of the unit housing.
2.
Align the front grille with the four (4) ball studs on the housing. Push the front grille onto the ball studs until it snaps into
place.
3.
Using a Phillips-head screwdriver, fasten the two (2) screws to fasten the grille to the unit.
INSTALLING THE DUCTED PLENUM
1.
If removed, reinstall the top panel of the unit housing.
2.
Align duct plenum with the four (4) ball studs on the housing. Push the duct plenum onto the ball studs until it snaps into
place.
3.
Using a Phillips-head screwdriver, fasten the two (2) screws to fasten the plenum to the unit.
4.
Connect the supply and return duct work to the unit.
5.
Using duct tape or foil tape, seal the seam between the plenum and unit.
6.
Insulate all exposed metal on the unit to prevent surface condensation.
NOTE:
Max ducting length is 25 feet.
NOTE:
A 12" x 12" return air filter grille must be installed to prevent contaminants from entering the cooling system. Supply and
return ducts must be insulated so they do not sweat or pick up heat.
DRAIN PAN
Page 18
08/04/21
