5. Place the display on the wall mount bracket as shown, attaching the back of the display panel to the magnets on
the mounting bracket. Make sure that the alignment tab on the back of the display panel sits in the notch on the
bottom of the bracket.
Wall mount
bracket
Display
DISPLA
Y
JST connector
WALL MOUNT BRACKET INSTALLATION, CONTINUED
NOTE:
Before you continue to Step 4, locate the area where the display will be mounted. You may route the display
wire into the housing one of three ways: either through the wall or through one of the holes on the top or bottom
edges of the wall mount bracket. If you’d like to route the display cable through one of these holes, place a rubber
grommet into the hole and then route the display cable through the grommet and into the wall mount bracket.
4. Connect the end of the display cable labeled “
DISPLAY
” to the JST connector on the back of the display.
Page 20
