Whirlpool WVH92K W, Instructions For Use Manual

Page: 74 / 192

74
“STAND ALONE” Timer
The Timer function is a countdown independent of the cooking
zones (and the extraction zone).
The timer is activated by pressing the Zone/Display (4)
Use the symbols (5) to set the duration of the
Timer ,which is displayed in the Zone/Display (4)
Note: wait 10 seconds without pressing any other command,
so that the countdown starts.
The format of the Timer is
.
- . for the times
- for the minutes
Note : the timer can be set up to a maximum of 1h and 59min
In the
Zone/Display (4) the remaining time will be displayed;
at the end of the countdown, an acoustic signal will sound
Note: in the display of the countdown, for a time less than 10
minutes, the following format is evident
-
. minutes
- seconds
with fixed light point
To switch off the Timer:
• select Zone/Display (4)
• set the duration of the Timer to , via (5)
Cooking Zones Timer
The Cooking Timer Zone function is a countdown that can be
set, also at the same time, on each cooking zone
At the end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated acoustic
signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2)
(power level
≠
0)
• Press (6) relating to the cooking zone
Use the symbols
(5) to set the duration of the
Timer, which is displayed in the Zone/Display (4)
during setting the symbol (6) is flashing
Note: wait 10 seconds without pressing any other command,
so that the Cooking Zone Timer will start.
Note: by pressing and holding (6) , the cooking zone
timer is reset
If desired, repeat the operation for several cooking zones .
Note : each cooking zone can have a separate Timer set; the
countdown for the selected cooking zone will be appear on the
display
(4) ;
If no cooking zone is selected and the STAND-ALONE timer is
not active, the timer closest to the end of the countdown is
displayed.
If no cooking zone is selected and the STAND-ALONE timer is
active, it is displayed with priority, with respect to the timer
closest to the end of the countdown.
The display mode of the countdown is the same for the
“STAND - ALONE” Timer (see previous paragraph “STAND -
ALONE” Timer )
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to , using (5)
Power Limitation
The Power Limitation function allows setting of the operation
of the product, limiting its maximum absorption.
Note: the setting must take place with the hob off, without
pressing the (1) key, when the hob is connected to
the mains, or when the electric mains are reconnected within
the following 2 minutes.
To set the Power Limitation:
- press
(which will be flashing, only for the first 2 minutes after
powering of the product)
- continuing to hold down
press, one at a time, all the
areas of Selection/Display (2) of the cooking zones, anti-
clockwise starting from the front right zone ( FR )
- each press will be accompanied by a short audible signal
- once
all the Displays (2) have been pressed, it will be
possible to release the key
at this point:
- the Display (2) of the left rear zone (RL) will show in
alternate sequence the symbols
“
C
”
and
“
0
”
, indicating that it
is possible to perform the setting:
select the Display ( 2-RL)