8
Remove Foam Packing
1.
Open the washer lid. The latch under the dryer will keep the
lid open.
2.
Pull the foam packing ring out of the washer.
NOTE:
Keep the foam ring and use it when transporting your
washer/dryer. This packing material is used to keep the washer
tub stable during transport.
Connect Drain Hose
Proper connection of the drain hose protects your floors from
damage due to water leakage. To keep the drain hose from
coming off or leaking, it must be installed according to the
following instructions:
IMPORTANT:
To ensure proper installation, this procedure must
be followed exactly.
1.
Check the drain hose to see whether it is the proper length.
2.
Wet the inside of the straight end of the drain hose with tap
water.
IMPORTANT:
Do not use any lubricant other than water.
3.
Squeeze ears of the silver double-wire clamp with pliers to
open. Place clamp over the straight end of the drain hose
¼" (6.4 mm) from the end.
4.
Open clamp. Twist hose back and forth while pushing onto
drain connector on the side of the washer/dryer. Continue until
hose contacts the ribbed stops on the cabinet.
5.
Place clamp over the area marked “CLAMP.” Release clamp.
For laundry tub or standpipe drain systems
1.
Make sure drain hose form is in correct position.
2.
Put the hooked end of drain hose into laundry tub or
standpipe. Rotate hook to eliminate kinks.
To keep drain water from going back into the washer
:
Do not force excess drain hose into standpipe. Hose
should be secure but loose enough to provide a gap
for air.
Do not lay excess hose on the bottom of the laundry tub.
For use with floor drain
Do not install the drain hose form onto the corrugated drain hose.
You may need additional parts. See Floor drain under “Tools and
Parts.”
Connect Inlet Hoses
1.
Insert a new flat washer into each end of the inlet hoses
(not provided). Firmly seat the washers in the couplings.
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1.
Attach hose to the hot water faucet. Screw on coupling by
hand until it is seated on the washer.
2.
Attach hose to the cold water faucet. Screw on coupling by
hand until it is seated on the washer.
3.
Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE:
Do not overtighten or use tape or sealants on the valve.
Damage to the valves can result.
Clear the water lines
Run water through both faucets and inlet hoses, into a laundry
tub, drainpipe, or bucket to get rid of particles in the water
lines that might clog the inlet valve screens.
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold water hose is connected to the cold water faucet.
¼"
(6.4 mm)
A. Drain hose form
A. Coupling
B. Washer
A
A
B
