2
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts supplied
■
Clamp brackets (2)
■
2
¹⁄₂
" (6.4 cm) clamping screws (2)
■
Foam strip
Parts needed
■
A UL listed or CSA approved conduit connector
■
UL listed wire connectors
Check local codes. Check existing electrical supply. See
“Electrical Requirements.”
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
Location Requirements
Make sure you have everything needed for correct installation. It is
the responsibility of the installer to comply with the installation
clearances specified in these instructions.
IMPORTANT:
Observe all governing codes and ordinances. When
installing cooktop, use minimum dimensions given.
■
To eliminate the risk of burns or fire by reaching over the
heated surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
that projects horizontally a minimum of 5" (12.7 cm) beyond
the bottom of the cabinets.
■
The cooktop must be a specified cooktop that is approved to
be installed either alone or over an undercounter built-in oven.
Check the cooktop base for an approved installation label.
Verify approved oven model numbers that can be installed
with your cooktop model number. If you do not find this label,
your cooktop may not be approved for use over an
undercounter built-in oven. Contact your dealer to confirm
that your cooktop is approved.
■
Ovens approved for this type of installation will have an
approval label located on the top of the oven. If you do not
find this label, contact your dealer to confirm that your oven is
approved. Refer to oven manufacturer’s Installation
Instructions for approval for built-in undercounter use and
proper cutout dimensions.
■
When installing cooktop over an undercounter built-in oven,
do not fasten cooktop to countertop with clamps or seal
cooktop to countertop. This will make the cooktop easier to
remove if future servicing becomes necessary.
■
Use the countertop opening dimensions that are given with
these Installation Instructions. Given dimensions are minimum
clearances and provide 0" (0 cm) clearance.
■
Grounded electrical supply is required. See “Electrical
Requirements” section.
Product Dimensions
Straight Edge Glass Cooktop
Curved Edge Glass Cooktop
■
Tape measure
■
Flat-blade screwdriver
■
Level
■
Marker or pencil
■
Pliers
A. 21
⁵⁄₁₆
" (54.1 cm)
B. 16
⁹⁄₁₆
" (42.1 cm)
30
⁵⁄₁₆
" (77.1 cm)
36
⁵⁄₁₆
" (92.3 cm)
C. 2
⁷⁄₈
" (7.3 cm)
D. Model/serial rating plate
A. 22
¹⁄₈
" (56.1 cm)
B. 16
⁹⁄₁₆
" (42.1 cm)
30
⁵⁄₁₆
" (77.1 cm)
36
⁵⁄₁₆
" (92.3 cm)
C.
2
⁷⁄₈
" (7.3 cm)
D. Model/serial rating plate
C
A
B
D
A
B
C
