c. Remove the clear silicone drain plug and allow water to drain out.
d. Re-attach the drain plug and plastic cap before proceeding.
4. Fill a bucket or empty 5-gallon water bottle with solution of white vinegar. For pro-
portions, refer to “Descaling Solutions” section. Choose quantity in accordance with
the frequency of your treatments.
5. Attach or insert the probe to the bucket/bottle.
6. Place the bucket/bottle into the cooler and close the door. The water will be pumped-
up into the holding tanks.
7. Wait for 1 hour.
8. Using rear drain plug, drain the water from the cooler into a bucket and discard the
water.
a. Locate the white plastic cap at the back of the cooler.
b. Remove the screw.
c. Remove the clear silicone drain plug and allow water to drain out.
d. Re-attach the drain plug and plastic cap before proceeding.
9. Fill the bucket/bottle with tap water and place into the machine.
10.Plug the cooler back into the wall, do not turn hot or cold switches ON, close the
door and wait for 10 minutes.
11.Dispense water from both cold and hot faucets until smell from cleaning substances
disappears.
12.Open drain plug and cap once again and drain all tap water.
13.Replace the drain plug and cap.
14.Place a fresh bottle of water into the machine and operate as usual.
15.This procedure must be repeated every 3 to 6 months, depending on mineral con-
tent and usage of water cooler.
Stainless Steel
tube for Self - Clean
function
Expandable telescopic
tube for drawing water
from the bottle
16
OPERATING YOUR COOLER
This water cooler is intended to use water only. Do
not try to
pump any other liquid through the suction tube. The warranty is
void if the cooler is used with any other liquid, such as coffee,
tea, juices, beer or wine.
This water cooler fits standard water bottles with a 3, 5 or 5.2
gallon capacity. Do NOT use alternative bottles. Avoid using
disposable bottles, since they lack rigidity.
Initial Set Up
Do NOT plug it in until instructed to do so below.
1. Allow the unit to sit upright for 4 hours.
2. This model uses a pump to pull water from the bottle to the
reservoirs. Please do the following:
NOTE:
