PAGE 2
Check location where washer will be
installed. Proper installation is your
responsibility. Make sure you have
everything necessary for correct
installation.
No. T20 Torx
screws
Hot and cold water faucets
must be
within 1.2 meters (4 feet) of the back
of the washer and provide water
pressure 690 kPa (10-100 PSI). A
pressure reduction valve should be
used in the supply line where inlet
pressure entering the building
exceeds 690 kPa (100 PSI) to prevent
damage to the washer mixing valve.
Grounded
electrical outlet
is required. See
Electrical
requirements.
Single washer
installations require
30 cm (12 inch)
minimum risers to
provide an air
cushion and
prevent noise and
damage to valves.
Untape and
open washer
lid. Remove
packages
and hoses
from washer.
Water heater:
Set to deliver
60°C to 70°C (140°F to 160°F)
water to the washer.
Standpipe drain system:
Needs a 5 cm
(two-inch) minimum carry-away
capacity of 64.4 liters (17 gallons) per
minute. Top of standpipe must be at
least 86.4 cm (34 inches) high and no
higher than 183 cm (72 inches) from
bottom of washer.
Support:
Floor must be sturdy enough
to support loaded washer weight of
143 Kg (315 pounds).
Level floor:
Maximum slope
under washer —
2.5 cm (1 inch).
On coin-operated washers, front
access to the pump area is available
by removing the two, No. T20 Torx
screws and then removing the front
panel.
Important: Observe all governing
codes and ordinances.
A floor drain
should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines and drain facilities
should be used only where local
codes permit.
Your safety and the safety of
others is very important.
We have provided many important
safety messages in this manual and on
your appliance. Always read and obey all
safety messages.
This is the safety alert
symbol. This symbol alerts
you to hazards that can kill or
hurt you and others. All safety
messages will be preceded by the safety
alert symbol and the word “DANGER” or
“WARNING”. These words mean:
All safety messages will identify the hazard,
tell you how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
You will be killed or seriously injured if
you don’t follow instructions.
You can be killed or seriously injured if
you don’t follow instructions.
DANGER
WARNING
Do Not store or operate washer below
0°C (32°F) (some water may remain in
washer).
See Use & Care Guide for
“Winterizing” information.
Before you start...
