Page 6 of 8
7. Carefully
pull
the
protective backing tabs
out from under the
FastTrax
housing.
Make sure that the
housing’s position is not
disturbed during this
process.
8. With
all
of
the
protective
backing
strips removed, press
down firmly along the
edges of the housing to
promote adhesion.
WARNING!The vehicle should not be driven for a minimum of 24 hours after
installation. The adhesive used in this procedure must remain at
65°F
(minimum)
for 24 hours
after installation. Caution should be used if the vehicle must be driven
between 24 and 72 hours after installation. The adhesive should be fully bonded
after 72 hours.
A Note On Painting the
FastTrax Housing...
If painting or re-painting your
FastTrax housing, it is important to
keep in mind the following
information:
•
Do not apply paint or primer
to any of the black-colored
area immediately adjacent to
the clear outer lens!
•
Do not apply paint or primer
to the underside of the
housing.
•
Make sure that all surfaces to
be painted have been primed
using primer that is suitable
for ABS plastic.
•
Be sure to include the leading
edges (material thickness) in
your painting surfaces.
2
2
3
3
1
1 = Control Connector
Pos.1 - No Wire
Pos.2 - Green
Pos.3 - Blue
= Pattern Selection Connector
Pos.1 - White/Red
Pos.2 - Brown
Pos.3 - White
= Power Connector
Pos.1 - Red
Pos.2 - Black
Pos.3 - Violet
(Optional)
S4
(A)
S4
(B)
S3
(A)
S3
(B)
S2
(A)
S2
(B)
S1
(A)
S1
(B)
3
FTF1
8 Strobe
0 Halogen
UPS158 Power Supply
S1
(B)
S4
(B)
S1
(A)
S4
(A)
S2
(A)
S3
(A)
S2
(B)
S3
(B)
T-D
T-D
(BOTTOM VIEW)
Protective
Backing
Cut
Protective
Backing
Here
(Do Not Cut
The Tape)
