Page 4 of 8
Feed this bundle
thru the side brace
cable entry opening in
the “C” pillar and
through the support
brace until it exits out
of the cable exit
opening shown in this
picture. Route the
cable bundle up
through the
grommeted hole. Be
sure to pass a
minimum of 18” of
cable through this hole
and out onto the roof.
Apply a generous
amount of RTV to the
grommet hole to
completely
water-proof this opening.
Insert the remaining pinned end of the cable bundle through the cable entry opening in the
“C” pillar and down through the “C” pillar until it enters the trunk area of the vehicle. In the trunk,
route the cable bundle towards the UPS158. The basic cable path is as shown.
Repeat this entire procedure using a cable bundle consisting of the remaining cables (
S3(A),
S3(B), S4(A), S4(B)
and
TD-2
) bundled together and routed along the driver-side support brace.
Insert the cable wire terminals into their plug connectors as follows:
Strobe Cable
Halogen Cable
Pin #1 -
RED
Pin #1 -
WHITE
Pin #2 -
BLACK
Pin #2 -
NO CONNECTION
Pin #3 -
WHITE
Pin #3 -
BLACK
The FastTrax™ housing mounting surface will now be prepared.
Cable bundle exiting
passenger-side
cable access hole
Cable bundle exiting
passenger-side
cable exit opening
To
Lighthead
To
Power Supply
