page 4 – 3
E-1 / Apr 2010
H A R D W A R E
Mixer Link Wiring
Note that this port is not used if the E-1 is part of a WheatNet-IP system.
This RJ-45 connection provides the control link between the control sur
-
face and the Bridge Router system. All settings and commands generated
on the control surface pass through this link. A special CAT5 cable wired in
“crossover” fashion is used for this link. This special cable connects the RJ-45
jack on the control surface to the matching RJ-45 jack on the Network Router
system. Please note that, in a typical system, there will be many RJ-45 jacks
in the Network Router, and for proper operation, the control surface must be
connected to the specific RJ-45 jack defined for it in the system configuration.
Internal Programming Options
All internal programming options are made via PCB mounted switches.
Switch Settings
SW1 Position 1 - Sample Rate
This dipswitch position must be set to agree with the sample rate of the
system. The switch is off for a sample rate of 44.1kHz and on for a sample
rate of 48kHz.
SW1 Positions 2 and 3 - Not Used
These dipswitch positions are reserved for future use.
SW1 Position 4 - CAT5 Enable
Position 4 of SW1 must be in the on position in order to activate the CAT5
mixer link connections.
All devices in the
system must be
set to the same
sample rate!
E-1 / May 2017