1
6WDQGVDQG%UDFNHWV
The bookshelf loudspeakers are intended primarily for stand mounting, though they can be mounted on wall brackets or even on sturdy
shelv
ǯȱȱ¢ȱȱȱȱ¢ȱĚȱȱȱȱ
y
ȱǰȱȱȱȱȱĚ¢ȱǯ
&HQWUH&KDQQHO/RXGVSHDNHUV
Each centre channel loudspeaker is supplied with one set of mounting feet. By using combination of large and small feet the loudspeaker may
be angled to point directly at the listening position. This will be found useful when the centre speaker is positioned under the TV screen.
3UHSDULQJWKH'LDPRQG/RXGVSHDNHUV
&DEOHVDQG&RQQHFWRUV
&KRRVLQJ/RXGVSHDNHU&DEOH
Choose a cable of suitable diameter – cable that is too thin will limit the dynamics of the sound and may impair the bass response. Audio cable
give careful thought to the positioning of your loudspeakers.
This is especially the case if you are bi-wiring your loudspeakers.
transmission. Allow some slack in your speaker cables so you can alter their position to best advantage.
3UHSDULQJ/RXGVSHDNHU&DEOH
Split the twin cores to a depth of about 40mm. Carefully strip the insulation from each end, leaving about 10mm of
bare wire. If the cable is stranded, lightly twist to gather any loose strands.
&RQQHFWLQJ6FUHZ7HUPLQDOV
All loudspeakers use screw terminals.
Unscrew the terminal. Insert the bare end of the cable into the hole in the base of the terminal. Tighten securely.
When connecting terminals make sure you leave no strands of bare wire that can short across to adjacent terminals.
As an alternative to bare wire you can use specialist spade connectors. Your Wharfedale dealer will be pleased to
advise you on this issue.
&URVVRYHU1HWZRUNV
%L:LUHDEOH1HWZRUNV
Most speakers in the Diamond 11
Ě
eaker use a special bi-wireable crossover panel with four
terminal binding posts. Please follow the drawing carefully to see the correct orientation of the
loudspeaker terminals.The upper terminals connect to the treble unit, the lower pair to the bass unit. As
supplied, the treble terminal pairis connected to the bass terminal pair via removable metal straps.These
:K\%L:LUH"
Using separate cables for treble and bass units in a bi-wiring
ę
reduces intermodulation
ěȱ
and improves headroom and clarity. To bi-wire, you will need to install two lengths of twin core cable
betw
ȱȱęȱȱȱ
r.
Standard Networks
The D11.0 ,D11.1,D11.2 compact monitor, the D11.CC and D11.CS,D11.CM
compact centre channel speaker D11.SR ,D11.DFS compact surround channel
speakerNone of the above loudspeakers are bi-wireable as smaller loudspeakers
derive no particular advantages from bi-wiring.
+
)
%
$
6
6
+
)
%
$
6
6
D11 bookshelf & centre
D11.0 & D11.1 & D11.SR
Summary of Contents for Diamond 11.0
Page 12: ...2 4 metres I 200mm 700mm 200mm 2 4m 11 ...
Page 13: ...C L L 12 ...
Page 15: ...5 1 14 R E B SUB WOOFER 5 1 DFS 6 1 DFS I I I I SUB WOOFER 7 1 DFS SUB WOOFER ...
Page 19: ......