Basic Operation
Receiver Instructions
Receiver LED STATUS LIST
PPM/W.BUS/PWM port modes select:
Enter the
interface [LINKAGE SETTING] - [RECEIVER
OUTPUT], switch the working status of the last port
of the receiver (default 6 channels), and return to
the previous interface to save the settings.
Link:
Charge the receiver then press and hold
'SET' button for 3 seconds,wait for the link
instruction after the orange light slowly
flashes(LINKAGE SETTING)→
（
LINK
）
.
Mode
LED
Action
Status
Work
Purple
Never
PWM normal work mode
Green
Never
W.BUS normal work
Blue
Never
PPM normal work mode
Red
Never
No signal
Red
Slowly flash
Low voltage
Orange Slowly flash
Linking
1.If there is a metal conductor around the receiver antenna,the signal performance would be affected.
In this case, the antenna should be bypassed by the conductor, placed on both sides of the fuselage, and
it is better to make the antenna leak outside the model casing ! In this way, good signal reception can be
maintained regardless of the flight attitude.
2. When the antenna is installed. The unshielded end of the antenna should be as far away as possible
from the conductor materials such as metal and carbon fiber. The antenna cable avoids bending at large
angles. And the end core should be as straight as possible.
3. If the model body is covered with a conductive material such as carbon fiber or metal, the antenna
portion must be extended beyond the body. At the same time, do not stick too close to the conductive body
after the antenna is extended. In addition, the antenna should also be kept away from the fuel tank.
The receiver has an external battery detection interface, which can be used to view voltage information
such as ESC, battery, etc., and the transmitter can separately set alarm voltages for the receiver voltage
and external voltage. Pay attention to the positive and negative polarity when using the detection wire!
Mandatory
90°
Keep the
antenna
straight
Signal
Positive
Negative
W.BUS/PPM/PWM
External voltage detection
port polarity signs
Ext
.
voltage
The resistance is connected
to the negative pole
The red is connected to the
positive pole
1
Ω
15
Notice:
pay attention to the positive and negative
polarity when connecting the power supply. Do not
use the power supply that exceeds the working
voltage of the receiver. Otherwise, the receiver will
be damaged!
Receiver connection and installation
The working voltage of the receiver is 3.8-6.5V.
Each port can be used as the power input terminal.
The RF206S is the newest series of high
performance receiver with 6 PWM channels, the last
channel port is PWM/PPM/W.BUS channel (User
defined).
In order to obtain optimal signal retrieval
performance, the two antennas are preferably
processed 90° to each other when installed, as
shown in the right diagram.
Summary of Contents for ET08
Page 83: ...83 ...
