PITCH CURVE
Interface path: HOME/MON. → [MODEL MENU] → [PITCH CURVE]
This function adjusts the pitch curve for each "fly condition" to get the best flight status following the
throttle stick action.
Standard curve
Idle curve 1
Idle curve 2
Throttle hold curve
Adjustment of the standard curve: Polyline is usually used. The standard curve is a basic curve set
around the hover. With the throttle curve (standard), the number of engine revolutions is fixed, making the
up and down control the easiest
Adjustment of the idle curve: The high pitch curve sets the maximum pitch that is not burdened by the
engine. The low pitch curve is set for the purpose of matching the movement of the ribs, the roll, and the 3D.
The idle curve is sometimes used depending on the stunt action.
Adjustment of the throttle lock curve: The throttle hold curve is used for the descent landing process.
* Flight mode: set "Fly Mode" control switch in "model function" → "Flight Mode".Switch through the
switch, respectively for function curve setting.
The following curves are made in the default polyline adjustment. When the curve is actually set, it is
input according to the specified (or reference value) action amount of the model.
Curve setting example
There are seven reference points
Adjust the selected curve reference point up and down offset,
confirm the key switch reference point (long press to reset value).
Adjust the rate of output value of left and right curves respectively.
"
Fly Mode" controls the pitch curve, and different modes are
enabled for curve adjustment when setting.
59
MODEL MENU \ HELICOPTER
WARNING
Start the engine. be sure to turn
off the “idle” function switch and
start the engine at idle down when flying.
Summary of Contents for ET08
Page 83: ...83 ...
