Glass
tilt
Rev. 2.0 (202202)
Installation instructions
25
Connection to the left- or right-hand side of the machine
1.
Water connection
2.
Electrical connection
3.
Floor drain
•
Attach the sink connection to the machine and then adjust.
•
Drill two ø 4.5 mm holes through the sink connection and the machine,
approx. 100 mm from each outer edge.
•
Countersink the holes.
•
Seal with silicone between the connection and the machine.
•
Secure the sink with countersunk M4 screws, grommets on the outside
surface and nuts. Alternatively, you can secure the sink to the wall with wall
brackets.
Use a spirit level to check that the sinks are horizontal and adjust the height, if
necessary.
3
2
A
A
1
A - A
G_300730_R2b