Glass
tilt
Rev. 2.0 (202202)
Operating instructions
52
Troubleshooting
The following errors can be dealt with by the operator. If the problem persists,
contact authorised service personnel.
PROBLEM
CAUSE
ACTION
No indication on the control
panel display when the control
button is pressed.
Power switch off.
Switch on the power switch.
The machine does not fill with
water.
The incoming water stopcock is
closed.
Open the tap.
The door/hood is open.
Close the door/hood.
The level pipe is not in place.
Fit the level pipe.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.
The rinse pipe nozzles are blocked.
Clean the wash nozzles.
The machine fills slowly.
The rinse pipe nozzles are blocked.
Clean the wash nozzles.
The machine does not stop
filling.
The level pipe is not in place.
Fit the level pipe.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.
The hood is not opened/closed
properly.
Air has got into the system.
Bleed the hood lifting cylinder as per
the manual.
The machine does not start
washing.
The door/hood is open.
Close the door/hood.
Dishware is blocking the magnet in
the door.
Remove the dishes in question.
Noise from the washing pump.
Low water level. Foam in the tank.
Check the level. Change the water.
The machine stops in the middle
of the washing cycle and starts
taking in water.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
Adjust the level pipe. Check that the
rubber sleeve has not been
damaged. Change the rubber sleeve
if it is damaged.
