15
Connection
Connecting several lamps
You can optionally connect lot of lamps of the issue SL-X, if desired. If the motion
detector - connected on one of the lamps – activates, all lamps will light up. For
this purpose, connect the terminals
M–
and
MSIG
of all lamps with each other.
Additionally you can operate these lamps with an external switch (see also
previous example). That way, you can manually switch on and off all lamps at the
same time. If the motion detector of some lamps should not activate all other
lamps, turn the middle switch of the motion detector of these lamps to the position
OFF
.
Each lamp has to be connected with its own solar module.
To bridge the terminals
M–
and
MSIG
, you can basically use a standard switch
or relay because no special standards are requested for the contact rating.
The voltage that has to be considered is totally 3 VDC. The electricity of each
connected lamp is only 225 µA.
Only connect potential-free contacts on the terminals
M–
and
MSIG
. Voltage-
carrying wires may destroy the electronics of the lamp.
The following WeTeLux stainless steel solar lamps with motion detector are
suitable for the above example.
Wall Lamp 41 cm incl. solar module..............SL-WM–P-SS–6-1 ...Art. 28 19 80
Stand Lamp 75 cm incl. solar module ...........SL-GM–P-SS–6-1 ....Art. 28 19 98
Spot + ground stake 40 cm + solar module...SL-SP-P-SS–6-1......Art. 28 20 04
Solar-
module
Solar-
module
Solar-
module
Summary of Contents for 39 90 06
Page 1: ...Westfalia Bedienungsanleitung Nr 107360...
Page 4: ...III bersicht Overview F D A B E C...
Page 16: ...11...
