10/22/2019
E
If light does not turn on, remove battery,
wipe both ends with a clean, dry cloth
and reinstall battery. Check the battery
to ensure that it is making secure
contact with the terminals.
If this does not work, replace with a
new battery.
REPLACING THE BATTERY
TROUBLE SHOOTING
INSTRUCTIONS
WARNING:
Do not dispose of lithium batteries in municipal waste stream or by fire as batteries may explode. Do not open, short circuit, or destroy
batteries. Dispose of batteries in accordance with Local, State, and Federal regulations. Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel cadmium, nickel metal hydride or lithium ion) batteries .
Tools Required
Phillips-head
Screwdriver
Pencil
Electric drill
drill bit size:
ø7.5mm (3/10 in.)
INSTALLATION
Hardware Included
Parts
Drill two holes.
1
Marking the location
Measure the width of two holes on the back of the solar fence
light to align holes for the 2 screws (Part A) on the surface. The
distance between the two holes is 4.7in. (120mm).
Mark the location where you want to mount the light
fixture (Part C).
2
Mounting the light
Insert the
wall anchors
(
Part
B) so they are flush with the surface.
Insert the screws (
Part
A) and leave at least 1/4in. (6.3mm) of the
screws (
Part
A) outside of the surface for holding the solar fence light.
Mount the light on the screws (
Part
A) by placing the keyholes
on the back of the light over the screw heads.
x
x
4.7in.
(C)
Light Fixture X 1
(B)
Wall Anchor X 2
(A)
Screw X 2
FOR FIRST TIME USE: SOLAR LIGHT NEEDS TO CHARGE IN FULL SUNLIGHT FOR 8 -12 HOURS WITH THE SWITCH IN
THE “ON” POSITION TO FULLY CHARGE THE RECHARGEABLE BATTERY.
IF INSTALLING MORE THAN 1 LIGHT, YOU MUST LINK YOUR LIGHTS FIRST BEFORE INSTALLATION BEGINS. YOU MAY
LINK UP TO 20 LIGHTS. AFTER THE LIGHTS ARE LINKED YOU MAY BEGIN THE INSTALLATION PROCESS.
The intelligent solar LED motion activated light measures the corresponding available battery power through the current voltage point of
the battery, adjusts the energy and lumen output, and maximizes the lighting time.
B
A
A
C
Slide the power switch to the “OFF” position. Use a
Phillips head screwdriver to remove 7
screws
from the light. Set 7 screws to the side. Remove
old battery and replace with a new 3.7V, 2000 mAh lithium
(18650) rechargeable battery. Replace the battery
cover by aligning it properly and replacing it with
7 screws removed earlier. Slide the power
switch to the “ON” position.
For optimum performance, allow light fixture to charge
in full sunlight for 8-12 hours.
Battery
Screws
Power Switch
Battery Cover
LINKABLE SOLAR LED FENCE LIGHT
ITEM: Q01DA0429-08
TM
Distributed by/Distribuido por
Wal-Mart Stores, Inc.,
Bentonville, AR 72716
MADE IN COUNTRY/HECHO EN COUNTRY
©2019 Wal-Mart Stores, Inc.
Hyper Tough is a registered trademark of
Wal-Mart Stores, Inc. All Rights Reserved.
For assistance with assembly or instruction, parts and customer service, call: U.S.A. & Canada only: 1-844-551-0680
8am – 5pm Monday – Friday, Central Standard Time Or email: [email protected]
