![background image](http://html1.mh-extra.com/html/wet-sounds/rev-10-hd/rev-10-hd_owners-manual_966495006.webp)
9
10
Step 1: Attach Male Connector (6) from clamp base to Female Connector (7)
Step 2:
(Optional Step
) If you use the RGB Lighting function, you will need to add
the optional six-pin female speaker plug (1) (Part# ADP TC3-S 6-PIN) to the
clamp. Once installed, connect the male four-pin RGB connector (10) to
the female four-pin RGB connector (11).
Step 3: Push all wires and connectors into the pod’s center hole as you place the
clamp base onto the speaker pod.
Step 4: Attach two M8x30 bolts (3) through the clamp base and tighten them
into the pod. Please make sure these are tight. We recommend using
threadlocker on these bolts.
Step 5: Separate the clamp base (9) and the detachment plate (2) by removing
the M8 x 45 bolt (5) and the detachment fork (4) to make the install easier.
Now you can mount the detachment plate to the tower without
holding the entire speaker in place.
Step 6: The detachment plate (2) will be hard mounted to a cast tower.
Butt connect speaker wires from the female speaker plug (1) to the
speaker wires from the tower. Red is speaker positive, and Black is speaker
negative. If using the RGB Lighting Function, reference the RGB wiring
diagram for RGB color options.
Step 7: Push wires into the center hole back into the tower and attach the
detachment plate to the tower.
Step 8:
(Recommended to be done by two people)
Insert clamp base (9) with
pod onto detachment plate(2). Please make sure the male and female
speaker plugs line up properly. The male speaker plug (8) inside the clamp
base can rotate. Please rotate this so that it is facing the proper direction.
A U-shaped groove on the female connector (7) lines up with a boss of the
male connector (6).
Step 9: The swivel clamp allows the speaker to rotate in any direction. Slide
detachment fork (4) and M8 x 45 bolt (5) onto the clamp base (9). Tighten
the Allen bolt, so the speaker does not move.
*Quick Release: (Recommended to be done by two people)
Loosen the M8 x 45
bolt (5) and remove the detachment fork (4) for quick speaker pod release. Once
removed, the clamp base (9) and pod will disconnect from the detachment plate
(2). To reinstall, make sure the male and female speaker plugs line up correctly and
insert the speaker. Once connected, reinstall the detachment fork.
(1) Female Speaker Plug
(3) M8 x 30
(4) Detachment Fork
(5) M8 x 45
(2) Detachment Plate
(9) Clamp Base
(8) Male Speaker Plug
Wet Sounds REV 10 HD & REV 12 HD Owner’s Manual
Wet Sounds REV 10 HD & REV 12 HD Owner’s Manual
Installation Specifications
ADP TC3-SXM | Swivel Surface Mount (no clamp)
(7) Female Connector
(6) Male Connector
(11) Female RGB Connector
(10) Male RGB Connector