Wet Sounds REV 10 HD & REV 12 HD Owner’s Manual
Wet Sounds REV 10 HD & REV 12 HD Owner’s Manual
8
7
Installation Specifications
ADP TC3-S | Swivel Clamp (tube diameter 1 7/8” to 3”)
Step 1: Attach Male Connector (8) from clamp base to Female Connector (9)
Step 2:
(Optional Step)
If you use the RGB Lighting function, you will need to add
the optional six-pin female speaker plug (13) (Part# ADP TC3-S 6-PIN) to the
clamp. Once installed, connect the male four-pin RGB connector (11) to
the female four-pin RGB connector (10).
Step 3: Push all wires and connectors into the pod’s center hole as you place the
clamp base (12) onto the speaker pod.
Step 4: Attach two M8 x 30 bolts (5) through the clamp base (12) and tighten
them into the pod. Please make sure these are tight. We recommend
using threadlocker on these bolts.
Step 5: Separate the clamp base (12) and the clamp bottom (3) by removing
the M8 x 45 bolt (7) and the detachment fork (6) to make the install easier.
Step 6: Find a mounting location for the speaker and clamp, and mark the pipe
where the speaker wire will pass through
Step 7: Drill a small hole in the pipe where marked and deburr the hole, so there
are no sharp edges. We recommend installing a rubber grommet in this
hole to protect the wire.
Step 8: Butt connect the speaker wire from the tower to the speaker wire from
the clamp bottom (3). Red is positive, and black is negative. If using
the RGB Lighting Function, reference the RGB wiring diagram for RGB color
options.
Step 9: Push wires into the center hole back into the tower and attach the clamp
top (2) to the clamp bottom (3) using the two M8 x 45 or M8 x 60 bolts (1)
depending on pipe diameter. Tighten the Allen bolts until there is no
movement.
Step 10:
(Recommended to be done by two people)
Insert clamp base with pod
onto clamp bottom. Please make sure the male and female speaker plugs
line up properly. The male speaker plug (4) inside the clamp base can
rotate. Please rotate this so that it is facing the proper direction. A
U-shaped groove on the female connector lines up with a boss of the
male connector.
Step 11: The swivel clamp allows the speaker to rotate in any direction. Slide
detachment fork (6) and M8 x 45 bolt (7) onto the clamp base (12). Tighten
the Allen bolt, so the speaker does not move.
*Quick Release: ( Recommended to be done by two people)
Loosen the M8x45
bolt (7) and remove the detachment fork (6) for quick speaker pod release. Once
removed, the clamp base and pod will disconnect from the clamp bottom. To
reinstall, make sure the male and female speaker plugs line up correctly and insert
the speaker. Once connected, reinstall the detachment fork.
(4) Male Speaker Plug
(1) M8 x 45/60
(9) Female Connector
(2) Clamp Top
(12) Clamp Base
(6) Detachment Fork
(5) M8 x 30
(7) M8 x 45
(3) Clamp Bottom
(8) Male Connector
(10) Female RGB Connector
(11) Male RGB Connector
(13) Female
Speaker Plug
