4
Westward Operating Instructions and Parts Manual 1KEN3, 1KEN4
10”,12” Drill Presses
Specifi cations for Drill Presses
WARNING
!
To avoid electrical hazards, fi re hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere time delay
fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is worn, cut or damaged in any way.
Before using your tool, it is critical that you read and understand these safety rules. Failure to follow these rules could
result in serious injury to you or damage to the tool.
Model
Horsepower (HP)
(Rated)
Speed (RPM) Chuck Size
Motor
Table tilt
Spindle
travel
Throat
Laser
Guide
10” Drill Press
1/3
5 (620~3100)
1/2 in.
120 / 60 Hz 45
0
Right or Left
2 in.
5 in.
Yes
12” Drill Press
1/3
12 (250~3100)
1/2 in.
120 / 60 Hz 45
0
Right or Left
2-3/8 in.
6 in.
Yes
