10
USER ACTION
Open the lid of centrifuge, correct the unbalanced load
by various methods described in the balancing the rotor
part of this manual. Then close the lid and `reset the
centrifuge’. Resetting is done by switching `Off’ and
again switching `On’ the centrifuge by using the On/Off
switch located on the rear side of the centrifuge.
15. WARRANTY STATEMENT
14. CARE & MAINTENANCE
This personal centrifuge and its rotor should be cleaned
periodically. Ensure that while cleaning the unit, it is not
plugged in to the main power supply. To clean this
centrifuge, use a damp cloth and a mild, noncorrosive
detergent (ph < 8). Do not immerse the centrifuge in
liquid or pour liquid over it. Excessive amounts of liquid
should be avoided, liquid should not come into contact
with the motor. After cleaning, ensure all parts are dried
thoroughly before attempting to operate the unit.
Should a spill of infectious materials occur within the
rotor or rotor chamber, the unit should be disinfected.
This should be performed by qualified personnel with
proper protective equipment. Do not use any cleaning
or decontamination methods except those recommended
by the manufacturer. Check with the manufacturer that
the proposed method will not damage the equipment.
This product is warranted to be free from defects in
material and workmanship for a period of two (2) years
from date of purchase. Your product will be duly
repaired upon prompt notification in compliance with
the following conditions :
This warranty is valid only if the product is used for its
intended purpose and within the guidelines specified
in this instruction manual. This warranty does not cover
damage caused by accident, neglect, misuse, improper
service, natural forces or other causes not arising from
defects in original material or workmanship. This
warranty does not cover any incidental or consequential
damages, commercial loss or any other damages from
the use of this product.
WESTLAB
SMART MICRO
CENTRIFUGE
USER MANUAL
CODE 663-958
C
