ICE AND WATER INSTALLATION
•
Always fit the filter as per manufacturer’s instructions.
•
If you need to replace water tube, only use approved water quality piping that meets the pressure requirements.
•
Make sure your refrigerator is level to avoid uneven ice cubes.
•
Replace filter at suggested intervals to avoid water/ice reduction and irregularities in taste.
•
Remove and clean ice bin once a month, discarding unused ice cubes. This will ensure fresh, clean ice and smooth
operation of your ice maker.
•
Clean and empty the dispenser drip tray regularly to avoid overflow.
If you have not used the dispenser for some time, discard the first seven or eight cups of water and any ice that the
ice maker produces in the first 24 hours (contaminants could have settled in the water pipes).
Water filter
The water filter is located at the top left side of the fresh food
compartment.
Replacing the water filter
You should change the water filter every six months to ensure the
highest possible water quality.
If your refrigerator has not been used for a period of time (during
a house move for example), change the filter before reinstalling
the refrigerator.
It is not necessary to turn the water supply off to change the filter.
Be ready to wipe up any small amounts of water released during the
filter replacement.
1.
Ensure that the ice maker is turned off (Diagram 1).
2.
Remove the filter by turning anti-clockwise 180˚.
3. Slide the old water filter cartridge straight out of the housing and
discard it. (Diagram 2).
4. Unwrap the new filter cartridge and using the alignment guide,
slide it gently into filter housing until it stops against the filter
connection at the back of the housing. (Diagram 3).
5. Engage the filter by firmly rotating clockwise until the filter snaps
into position (once engaged the filter cannot be rotated further).
(Diagram 4).
6. Press a drinking glass against the water dispenser while checking
for any leaks at the filter housing. Any spurts and sputters that
occur as the system purges air out of the dispenser system
are normal.
7.
After filling one glass of water, continue flushing the system for
about four minutes.
8. Turn on the ice maker. (Diagram 5).
9. When the filter has been replaced press and hold the ‘Ice and
Water’ button for three seconds to reset the filter replace timer.
Diagram
am
Diagram
am
m
Diagram
a
Diagram 1
Diagram 5
IMPORTANT
WARNING
16
INSTALLATION
