36
Assembly | Operation
▪
A sharp saw chain produces
large cutting-chips and pulls
itself automatically into the
timber. When it begins to
become blunt, or starts to
show signs of abrasion,
progressively saw-dust will
form during any cutting operation. You have to sharpen the chain
when you notice that excessive force is needed to cut through the
timber, i.e. if the saw does not
“pull” anymore.
▪
If too much material is grinded from the cutter teeth, the cutter teeth
will anneal and become useless.
Before Use
Please note that that battery and charger are not included with the
tool.
Removing the Battery
To remove the battery from the device, press the battery release button,
then slide the battery off the recess.
WARNING: Do not try to remove the battery without pressing the battery
release button. The device or battery could be damaged.
Fitting a Battery
To fit a charged battery, slide it on to the recess of the device until it clicks
and locks into position.
Note: Make sure the battery and device are lined up correctly. If the
battery does not slide into the device easily, do not force it. Instead, slide
the battery out of the device again, check the top of battery and the device
battery slot are clean and undamaged and that the contacts are not bent.
Setting up the Battery Charger
(Battery and Charger not Included)
1. If fitted, remove any battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
not ok ok
