Using
14
12. If the filling bottle fluid level gets low, close the lever (4) and refill
the filling bottle with clean, new brake fluid. Reattach the filling
bottle to the master cylinder and open its lever. Then, resume
bleeding the brakes.
13. If the collecting bottle is full, or when done bleeding the brakes:
-
Disconnect the air supply from the gun handle (7).
-
Empty the collecting bottle (5) of old brake fluid.
-
Reassemble the gun handle (7) and collecting bottle (5), and
resume bleeding the brakes.
14. When clean, new brake fluid with no bubbles begins to flow into
the collecting bottle, release the trigger (9) and re-tighten the
cali
per’s bleeder screw.
15. Disconnect the bleeding hose (6
) from the caliper’s bleeder
screw.
16.
Proceed to the vehicle’s next wheel, and perform the same steps
as above.
17. When finished, close the lever (4) and remove the filling bottle
(2).
18. Make sure the master cylinder is full of brake fluid up to, but not
over, it’s full line. If the master cylinder is too full, correct this
before proceeding!