2
Safety Notes
Please read this manual carefully and use the unit only according to this
manual.
Dispose of used packaging material carefully or store it out of the reach of
children. There is a danger of suffocation!
Make sure the power mains voltage in your area corresponds with the
operating voltage stated on the type label.
Do not use damaged grinding stones. Before every use, check the grinding
stone for cracks or other damage.
Grinding stones, flanges, dishes and other attachments must precisely fit the
shaft of your electric tool. Attachments which do not fit the shaft precisely will
rotate unevenly, vibrate and may cause loss of control.
Diameter and thickness of the grinding stone must correspond to the
requirements for your electric tool. Attachments of the wrong size cannot be
guarded or controlled properly.
Use only grinding stones which conform to the technical data within this
manual.
Use only water for wet grinding; do not use any other liquid.
Do not use an wet grinder close to inflammable materials. Sparks may ignite
such materials.
Keep the power cable away from spinning attachments.
Use the wet grinder only for grinding cutting edges. Other uses may lead to
damage of the wet grinder.
During work keep an eye on the water level in the water container. If the
stone is running dry, that may lead to overheating of the work piece and
damage to the stone.
Use only moderate pressure when working with the unit. Do not use
excessive pressure which may slow or even stop the stone.
If you see smoke during operation, stop operating it immediately and
disconnect the unit from the power mains.
The unit is designed for operation in altitudes of up to 2000 m above sea
level.
Please note the included General Safety Notes and the following
safety notes to avoid malfunctions, damage or physical injury:
