21
1) Air Paint Spray Gun
5. Hold the spray gun vertically to the surface to be sprayed and move the
spray gun evenly and in parallel lanes from one side to the other.
6. Start spraying openings and corners of the object. If necessary, take a
short break after each spraying process, so the paint may evaporate. Each
lane should overlap to at least 50%. Move the gun evenly and always
horizontal to the object. Always work from top to bottom. Move the spray
gun over the edges of the object so that the edges get enough paint.
7. If you do not use the paint spray gun for a short time, turn off the air supply
and release the pressure.
8. Check the paintwork on all sides, before cleaning the spray gun. After work
empty the paint container into an appropriate bin. Properly dispose of
coating material that is no longer needed.
Recently treated surfaces must not be exposed to direct sunlight, to very
high or low temperatures, wind, dust, water or rain.
Cleaning
When using water-soluble coating material, simply clean all parts of the air
paint spray gun thoroughly with water.
Intensive Cleaning
Please note that disassembling and intensive cleaning of the paint spray
gun are inevitable, as otherwise it can lead to debris and to a bad spray
result, if lacquer and priming coats are used as coating material.
Clean the paint spray gun and the paint container after each use with
appropriate paint thinners or cleaning agents. Empty the contents. Fill a
little paint thinner into the paint container and rinse it. Empty the paint
container and repeat the process again with clean paint thinner. Spray the
clean paint thinner in short strokes.
During cleaning please always wear a mask and solvent-resistant gloves!
Also wear eye protection, as splashes of solvents can cause injuries of
your eyes.
Never put the paint spray gun into solvents for a longer period of time or
overnight.
Never use hard or sharp objects to remove paint residues. The nozzle must
always be kept clean. Debris of dried paint can distort the paint jet and
damage the spray gun.
Rinse all parts well after intensive cleaning and dry the paint spray gun.
Assemble the gun. Fill a small amount of paint thinner into the paint
container and blow it with compressed air through the spray gun.
