Western Snowplows Midweight Series, Mechanic'S Manual

Page: 13 / 104

Lit. No. 48163, Rev. 00 March 15, 2016
13
2. Insert the 1/4" roll pin.
3. Do not cut the spring tie until after the final
stand shoe adjustment.
STAND SHOE HEIGHT ADJUSTMENT
Initial stand shoe height adjustment is based on
the receiver height measurement (distance "d")
determined in Step 1 under "Determine Pivot Plate
Hole Position" on previous page. A final adjustment
of the stand shoe will be made after attaching the
snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and
align the 1/4" hole in the stand tube with the
1/4" hole in the stand shoe as determined from
the chart and illustration.
Stand Shoe Position Chart
Distance "d" Position
13.0" – 14.5" 1
14.5" – 16.0" 2
16.0" – 17.5" 3
17.5" – 19.0" 4
WARNING
The stand plunger spring is shipped
compressed and tied. Do not cut the
spring tie until final stand shoe adjustment
is complete and the roll pin is installed.
Position 1
Position 2
Position 3
Spring Tie
Position 4
1/4" Roll Pin
BLADE, A-FRAME & LIFT FRAME — UltraMount
®
2