2.3
INNER INSULATING LINER ASSEMBLY AND DISASSEMBLY
Part
Component
Q.ty x tent
3A
4A
5A
1
Front insulation liner
1
1
1
2
Central insulation liner
-
1
2
3
Rear insulation liner
1
1
1
4
Modules joint
1
2
3
Figure 2.9 - Insulation liner diagram.
NOTE:
THE FOLLOWING INSTRUCTIONS ARE VALID IN CASE OF THE LINER IS NOT ALREADY PRE-INSTALLED ON THE
TENT. IN THIS CASE ASSEMBLY THE INNER INSULATING LINER ONCE TENT IS INFLATED BUT BEFORE INSTALLING
SPACER RODS (purlins).
A
- Install the front section by connecting the frogs of the liner to the studs of the arch structure (fig. 2.10 step 1);
B
- Install the internal section as described above, joint the front and central sections by means of the Velcro tape (fig. 2.10
step 2);
C
- Install the rear section as described above, connecting the Velcro tape (fig. 2.10 step 3);
D
- Provide to install the alloy spacer rods passing them between the holes of the insulating liners (fig. 2.10 step 4).
NOTE:
THE TENT CAN BE FOLDED AND RE-PACKED WITH THE INSULATING LINER INSTALLED. IF YOU WANT TO
DISMANTLE THE INSULATING LINER, REVERSE THE PROCEDURE TO DISASSEMBLE.
Summary of Contents for AIRFRAME SENTINEL II
