User Guide
4. Part Replacement
4.9 Chassis Replacement
Figure 177:
Tightening the Thumbscrew
a.
Check that the crossbar is fully secured to the CMA mounting bracket by pulling on the
bar to ensure it does not move.
Step 46 :
Cable the CMA(s).
a.
Unlatch the elbow side of the arm(s) by pressing the blue button labeled “push,” and then
swing the arm(s) open.
b.
Gather the SAS, power, and Ethernet cables for installation. Before cabling, note the
following routing patterns for best results:
Note:
Route the cables supported by the lower arm to IOM A (left
hand side looking at the rear). Second, route the cables supported
by the upper arm to IOM B (right hand side looking at the rear) in
a "criss-cross" pattern. See the
Special Considerations for Cable
for more information.
151
