8
HOW TO ADJUST THE REED SWITCH
If the console displays incorrect feedback, the reed
switch should be adjusted. In order to adjust the reed
switch, the Left Side Shield (10) must be removed.
Using an adjustable wrench, turn the Left Pedal (8)
clockwise and remove it from the Crank (22). Remove
the three M4 x 32mm Screws (40) from the Right Side
Shield (11) and the two M4 x 16mm Screws (46) from
the Left Side Shield. Make sure that the arm of the
Crank (22) is in the position shown in the drawing.
Then, carefully slide the Left Side Shield forward off
the arm of the Crank and remove it.
Next, locate the Reed Switch (49). Turn the Crank
(22) until the Magnet (4) is aligned with the Reed
Switch. Loosen, but do not remove, the M4 x 16mm
Screw (46). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (15) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. See the instructions above and
remove the left side shield.
Next, turn the
resistance knob to
the lowest setting.
Locate and open
the Strap Clamp
(38). Grip the end
of the Resistance
Strap (15) and pull
it up slightly. While
holding the end of
the Resistance
Strap,
fully close
the Strap Clamp. Turn the Crank (22) for a moment to
make sure that there is not too much resistance.
When the Resistance Strap is properly adjusted, reat-
tach the left side shield and pedal.
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a drive belt that must be
kept properly adjusted. If the belt causes excessive
noise or slips as you pedal, the belt should be
checked. To do this, the side shields must first be
removed. See the instructions at the left and remove
the left side shield. Next, remove the right side shield
in the same way.
Locate the Drive
Belt (14). Press
down on the cen-
ter of the Drive
Belt between the
front and rear
pulleys.
There
should be from
1/4” to 1/2” of
movement in
the center of
the Belt. If the
Belt is properly
adjusted, reattach the side shields and pedals. If the
Belt needs to be adjusted, loosen the Nylon Locknut
(36) on the left side of the Flywheel (29). To tighten
the Belt, turn the Adjustment Bolt (31) clockwise; to
loosen the Belt, turn the Adjustment Bolt counter-
clockwise. Make sure that the Flywheel is straight and
tighten the Nylon Locknut (36). Reattach the side
shields and pedals.
22
29
Top View
14
36
31
38
10
22
11
46
8
40
40
22
49
46
4
15
