5
4
5
4. Slide the Backrest Frame (20) into the Lower Seat
Frame (58). Attach the Backrest Frame with two M8
x 36mm Hex Head Bolts (56) and two M8 Split
Washers (57).
Attach the Backrest (21) to the Backrest Frame (20)
with four M6 x 16mm Screws (55).
5. Slide one of the Handlebars (6) onto the left side of
the Seat Frame (3). Insert two M6 x 34mm Button
Head Bolts (19) into the Handlebar and the Seat
Frame.
Make sure that the end of the Handlebar
angles upward. If the Handlebar does not angle
upward, slide the other Handlebar onto the left side
of the Seat Frame. If the Handlebar angles upward,
tighten two M6 Locknuts (52) onto the Button Head
Bolts.
Assemble the other Handlebar (7) in the same way.
Attach the Seat (54) to the Seat Frame (3) with four
M6 x 16mm Screws (55).
21
20
57
55
56
58
19
6
52
54
7
55
3
55
48
Console
Plate
Console
Wire
8
22
9
49
6
6. The Console (48) requires two “AA” batteries (not
included). Alkaline batteries are recommended. See
the inset drawing. Remove the battery door from the
Console. Press two batteries into the battery com-
partment.
Make sure that the negative ends of the
batteries (marked “—”) are touching the springs
in the battery compartment. Reattach the battery
door.
Slide the Console (48) onto the console plate. Make
sure that the plastic clip on the back of the Console
snaps onto the tab on the console plate.
Connect the console wire to the Reed Switch Wire
(49).
Identify the Left Pedal (8), which is marked with an
“L.” Using an adjustable wrench, tighten the Left
Pedal counterclockwise into the left arm of the
Crank (22). Next, tighten the Right Pedal (9) clock-
wise into the right arm on the Crank.
7.
Make sure that all parts are properly tightened before you use the exercise cycle.
Battery Door
Batteries
48
