Automatic sauna splash system, type Sauna Plus 8 Basic
Index: 02
Date modified: 22/02/2022
OI No.: BA DW 010-02 Sauna Plus 8 Basic EN.docx
Page 21 of 36
6.3
The menu
Start display key
31.
Device name
32.
Set pause time or locking time, respectively
33.
Set time for water dosing
34.
Set time for fragrance dosing
35.
Time until the start of the next splash or until the
end of the locking time, respectively.
36.
Display for the operating contact
37.
Display for the push button contact
After activating the device with the main switch located on the side, the set switch-
on delay starts and runs down to “0”.
After that, the display switches to the Start Display, showing the following information:
Device name as well as signalling of push button contact and operating contact
Set pause time or locking time, respectively
Set time for water dosing
Set time for fragrance, dosing
Time until the start of the next splash or until the end of the locking time, respectively.
Operating contact:
The operating contact is used to switch the device to standby mode via an external signal. In standby
mode, only the parameters and test functions can be operated.
The Operating contact function is active in all operation modes and is always displayed.
If the black square
is shown in the display, the operating contact is closed
Normal operation.
If the white square
is shown in the display, the operating contact is open
Standby mode – no splash.
Push button contact:
The push button symbol appears in the display when the
Button operation
operation mode is set.
If the black dot is shown in the display, a signal is pending at the button input or at the input of the
230 V control unit. A splash occurs.
If the white dot is shown in the display, no signal is pending at the button input or at the input of the
230 V control unit.
6.3.1
Operation modes
There are 2 operation modes to choose from:
Cyclic operation
and
Button operation
.
Cyclic operation:
The
Cyclic operation
operation mode can be used to specify an individual splash cycle, which is constantly
repeated. The water quantity, fragrance quantity and pause time can be set.
Special case:
In
Cyclic operation
, a splash can also be started with the push button. In this case, the pause time starts
again from the beginning.
Button operation:
With the
Button operation
operation mode, the pool visitors can determine the time of the splash them-
selves. The splash is started via a push button in the sauna. The water quantity, fragrance quantity and
locking time can be set individually. No splash can be triggered during the locking time.
If the
Button operation
operation mode is selected, the push button symbol
/
is shown in the
display. For this function, the operating contact must be closed.
!
Figure 22, Start display - Explanation
!
