Automatic sauna splash system, type Sauna Plus 8 Basic
Index: 02
Date modified: 22/02/2022
OI No.: BA DW 010-02 Sauna Plus 8 Basic EN.docx
Page 14 of 36
Installation plan, non-draining splash line
4.3
Mechanical installation
Installing dosing device
With the exception of the roller carrier, the SAUNA PLUS 8 Basic dosing device is delivered ready for op-
eration. It should be installed in an easily accessible location.
The splash line to the oven shower head must be installed with a gradient of at least 1 cm per 1 m of
line length! The oven shower head, in turn, must be mounted approx. 10-15 cm above the sauna heater.
Securely attach the mounting plate on the wall with 4 screws and ensure easy accessibility.
Install wall bushing for oven shower head (option)
Tip!
For the installation and secure fastening of the oven shower head, a wall bushing with
two 3/8” AG thread connections made of stainless steel is available (see Chapter
3.2.5).
Drill a hole of approx. 18 mm in the sauna wall approx. 10-15 cm above the heater, then insert the wall
bracket with the rosette from the inside. The rosette is attached to the sauna wall with the V4A screws
supplied.
NOTICE! Underbench heaters
If the automatic sauna splash system is connected to an underbench heater, make sure
that it is professionally connected to the connection pipe prepared on the heater side!
Please pay attention to any specifications by the heater manufacturer.
Figure 11, Installation plan 2
Technical room
Cabin
Oven
shower
head
Sauna
heate
r
Cab
in
wall
Inlet
