26
IO-Link
Function
Possible Settings
Default
Interference filter
The interference filter can be used to increase measurement reliability
in the case of brief interferences in the measured section. Interferenc-
es such as rain, snow or chips in the air generate brief signals, which
can result in incorrect measurements. A higher filter level allows the
interfering signals to be ignored for a defined period. If the distance
changes suddenly, the response time is extended. This extension of
the response time depends on the filter level and the mode used. If the
distance changes continuously, the response time remains unchanged
when the filter is activated.
Mode
Filter
Speed
Precision
Precision Plus
Off
—
—
—
1
2 ms
10 ms
20 ms
2
4 ms
20 ms
40 ms
3
6 ms
30 ms
60 ms
4
10 ms
50 ms
100 ms
5
20 ms
100 ms
200 ms
6
40 ms
200 ms
400 ms
7
60 ms
300 ms
600 ms
8
100 ms
500 ms
1,000 ms
9
200 ms
1,000 ms
2,000 ms
Off
Emitted light
The sensor’s laser can be switched on or off.
On
Laser on
Off
Laser off
The sensor no longer supplies a measured value.
NOTE!
• If an input is set as a laser-off input, the emitted light
can also be switched on and off via the input.
• If the laser is switched off, the sensor behavior corre-
sponds to the status “No signal.”
On
Localization
The switching status indicators of the sensor can be switched to flash-
ing. This allows the sensor to be easily located in a plant.
On
LEDs flash
Off
LEDs function normally
Off
Measured value
unit
The measured distance can be read out in millimeters or inches.
Millimeter
Distance values read out in mm
Inch
Distance values read out in 1/10 inch
Millimeter
