note:
The Showmobile must be level with all jacks contacting the
ground before opening the canopy.
After raising the roof/canopy, lower and level the hydraulic stage:
note:
On a Showmobile with the hydraulic leveling option, there is
a limit switch to prevent lowering or raising the hydraulic stage if the
roof/canopy is not high enough for the stage to clear or if the flip-
down panels are not unfolded and extended.
1. Set the stage switch on the remote control to lower. Stop
the stage momentarily about two-thirds of the way down,
so the legs can be released from their retaining magnets.
2. Continue lowering the hydraulic stage until it is level
with the main stage.
3. Level the hydraulic stage using leg extensions and appropriate
blocks as required:
note:
The length of each leg is adjustable. There are holes in
both the inner and outer leg members at different spacings. Only
one set of inside and outside holes align at any time. You may
wish to raise the hydraulic stage slightly to adjust the length of
each leg.
a. Remove the locking pin from the first leg. Adjust the inner
member, then reinsert pin into holes that most closely align.
b. Repeat the procedure on each of the other legs.
c. Make final adjustments as necessary to ensure that the
entire floor is level.
d. Lock the adjusting pin on each leg, using the attached
retaining clip.
e. Be sure the stage legs are supporting the stage.
note:
Return leg extensions to original position after every use to
avoid damaging stage when lowering it onto a different surface contour.
4. When the hydraulic stage is level unfold the two flip-down corner
panels.
a. Move one of the two flip-down corner panels to the performance
position.
b. Unlatch the panel by pulling the handle until the latch unhooks
from the groove in the end of the panel.
c. Lift the panel upward half-way and then pull the leg from the
magnetic latch.
d. Lower the panel allowing the leg to swing downward until the
panel rests on the frame and is flush with the other stages.
e. Adjust the leg as described in the previous section,
Lowering
and Leveling the Hydraulic Stage
.
f. Lower the other flip-down corner panel by repeating steps 4a to
4e.
16
LOWERING AND LEVELING THE HYDRAULIC STAGE
!
WARNING
adjust stabilizing
jacks and open end
panels before
raising roof/canopy.
!
CAUTION
be sure the area in
front of the stage is
clear of people and
obstructions.
latch
Summary of Contents for Showmobile
