12
LEVELING THE SHOWMOBILE
(
CONTINUED
)
hydraulic leveling (optional) using the wireless remote control
important:
Before using the wireless remote control,
be sure the following have been completed:
• The Showmobile is unhitched from the tow vehicle.
• You have checked the front, rear, or overhead
clearances required for the particular operation.
• The battery has been fully charged.
To level the unit hydraulically using the wireless remote control:
1. Open the control compartment.
2. Set the 60-minute timer switch to the desired time.
The switch will not function unless its knob is turned
past the 10-minute position.
Activating the timer switch energizes the under-chassis
angle sensors, the roof limit switch (see p. 13), and the
receiver module in the control compartment. The remote
control will not operate if the timer switch is off and will
not work unless the timer is turned on before the remote.
3. Remove the remote control from the control
compartment, and set its transmitter switch to on.
4. Move one of the upper four switches to the raise
corner position. When that stabilizing jack is in
contact with the ground and the corner of the
Showmobile starts to raise, set the switch back to
its neutral (center) position.
Repeat this process on the other three corners.
5. After all four stabilizing pads are in full contact
with the ground, press and hold the red auto level
button. The Showmobile will begin to raise to
properly level its chassis.
When the leveling is complete, the Showmobile will
stop moving and you will no longer hear the hydraulic
motor running. Release the auto level button.
note:
If the Showmobile stops moving but
the hydraulic motor continues to run, the slope
of the ground exceeds the limits of the leveling
system. You will have to place blocks under
the low end or side of the stabilizing jack pads
to increase the stroke capabilities of the jacks.
Abbreviated Procedure for Hydraulic Leveling
1. Set the timer.
2. Turn the wireless remote control on.
3. Lower all corner jacks until they are in full
contact with the ground.
4. Press and hold the auto level button.
Timer
Switch
Receiver
Module
Summary of Contents for Showmobile
