9
INSTALLING THE FRONT HANDLE
1. Install the front handle (Fig. 4 - 1) onto the stand body.
Secure it with four M8x40 bolts (Fig. 4 - 2) and M8 lock
nuts (Fig. 4 - 3). Tighten using the included 5mm hex
wrench and 13mm wrench.
MOUNTING THE SAW TO THE STAND
1. Place the saw onto the saw body. You can place it facing
either direction, so long as the horizontal mounting holes
(Fig. 5 - 1) on the base of the frame are aligned with the
rectangular holes in the saw body bracket. Secure the saw
to the base using four M8x40 partially-threaded carriage
bolts, 8mm washers, and M8 lock nuts. Tighten using the
included 5mm hex wrench and 13mm wrench.
NOTE:
Make sure the rectangular brackets are on the in-
side, and the saw frame is on the outside.
NOTE:
Make sure the bolts’ square necks sit fully in the
rectangular holes in the saw body brackets.
2. Make sure all fasteners are tight.
ASSEMBLY
Fig. 4
Fig. 5
2
3
1
1
1
WHEN YOU’RE READY TO MOVE YOUR SAW:
1. Make sure any and all loose accessories on the saw itself are secure.
2. Collapse the legs by pressing the detent buttons (Fig. 1 - 1) and folding the legs inwards. Have an assistant help
you hold the stand while doing this, if needed. Be careful not to pinch yourself.
NOTE:
You can fold the legs in any order.
3. Lower the stand to the ground. Pick the stand up by the front handle (Fig. 4 - 1) and roll it wherever it’s needed.
4. To reassemble, press the detent buttons (Fig. 1 - 1) and fold the legs out. Have an assistant help you hold the
stand while doing this, if needed. Be careful not to pinch yourself.
OPERATION
